1. Avoid engaging the clutch abruptly. Instead, slowly release the clutch pedal while gradually increasing the throttle. This helps prevent excessive stress on the clutch assembly and transmission components, which could lead to damage if done incorrectly.
2. Do not hold the secondary clutch in the disengaged position for extended periods. Prolonged disengagement can cause premature wear and damage to the clutch system. Always ensure it is properly engaged when needed.
3. Never shift the tractor into neutral or depress the clutch pedal while descending a slope. Doing so can result in loss of control and potential accidents. Always keep the clutch engaged and use engine braking when necessary.
4. When steering a tractor, reduce the throttle or shift to a lower gear before making turns. Avoid using only one brake to make sharp turns, as this can cause instability and damage to the vehicle's components.
5. Proper gear selection and speed management are essential for safe and efficient operation. Changing gears while the clutch is still engaged can cause unnecessary strain on the steering system. Operating the tractor at an appropriate speed ensures optimal performance, fuel efficiency, and longevity. Avoid overloading the engine and maintain some power reserve to handle varying workloads. For field operations, aim to run the engine under about 80% load for best results.
6. Use the differential lock only when necessary. It should remain disengaged during normal operations. If the rear wheels begin to slip, especially in soft or muddy conditions, engage the differential lock by pressing the control pedal. However, remember that the tractor cannot turn while the differential is locked, which may cause tire wear, damage to the drive system, or even a rollover if not handled carefully.
7. When braking, always follow the correct procedure: first reduce the throttle, then press the main clutch pedal, and finally apply the service brake gradually. In emergencies, press both the clutch and brake pedals simultaneously. Never place your foot on the brake or clutch pedal while driving. Also, ensure the left and right brake pedals are interlocked when operating on roads. When parking on a slope, shift into gear before releasing the brake after turning off the engine—use forward gear when going uphill and reverse when going downhill.
8. Engage the front-wheel drive only when working in heavy or wet soil conditions. On hard, paved roads, keep the front axle disengaged to avoid unnecessary wear on the front tires and drivetrain.
9. The hydraulic output valve controls the four-wheel drive function. Tractors typically come with either a single-acting or double-acting valve. The operator can adjust the valve to match the type of implement being used. Most tractors are set to double-acting at the factory, but single-acting configurations can be adjusted by the user if required.
10. Follow proper oil and fuel guidelines: 1) Choose the appropriate diesel grade based on climate and season. Never mix different diesel grades. 2) Filter or let the fuel and transmission oil settle for at least 48 hours before use to remove impurities. 3) Never refuel while the engine is running. Avoid filling the tank in hot weather, as fuel can expand and overflow. If any spill occurs, clean it immediately to prevent fire hazards.
Alaska Dried Fish,Dry Fish,Alaska Dry Fish
Yanji Yongzhen Food Co., Ltd , https://www.yanjiyongzhenfood.com