1. After buying a new camera, before using the engine, you must first carefully read the instruction manual of the machine. Pay special attention to the basic requirements of the book:
(1) Use fuel of specified grade, fully precipitate and filter before use, and the oiler should be kept clean.
(2) Lubricants should be kept clean, and the amount added must be sufficient, and they should be replaced regularly. The use of the brands should be consistent with the regulations.
(3) The air cleaner should always pay attention to maintenance.
(4) Care should be taken to add cooling water, and in particular not to leave the engine in a state of water shortage.
(5) Always pay attention to check and tighten the relevant bolts and nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nuts on the flywheel, and the fastening nuts on the wheels.
If the user buys a new camera and really does it in accordance with the above basic requirements, then the life of the camera can be greatly extended.
2. After buying a new machine, do not carry the load operation immediately. It should be run-in according to the instructions. After running-in, the machine oil filter is cleaned and the residual impurities in the oil are removed. If necessary, the oil must be replaced and the oil pan cleaned.
(1) Use fuel of specified grade, fully precipitate and filter before use, and the oiler should be kept clean.
(2) Lubricants should be kept clean, and the amount added must be sufficient, and they should be replaced regularly. The use of the brands should be consistent with the regulations.
(3) The air cleaner should always pay attention to maintenance.
(4) Care should be taken to add cooling water, and in particular not to leave the engine in a state of water shortage.
(5) Always pay attention to check and tighten the relevant bolts and nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nuts on the flywheel, and the fastening nuts on the wheels.
If the user buys a new camera and really does it in accordance with the above basic requirements, then the life of the camera can be greatly extended.
2. After buying a new machine, do not carry the load operation immediately. It should be run-in according to the instructions. After running-in, the machine oil filter is cleaned and the residual impurities in the oil are removed. If necessary, the oil must be replaced and the oil pan cleaned.
3, when the new machine carries on the work, should carry on strictly according to the request of the manufacturer's instructions, does not overload, does not surpass the speed, does not surpass the feed, does not work for long-term overload.
4. It is not free to modify the new machine and increase the engine speed arbitrarily. In order to make the machine run faster, some users may arbitrarily adjust the oil supply and pressure of the high-pressure oil pump, and some of them tie the governor spring wire. This is even more wrong.