Have you encountered these problems when using an oral liquid sealer?

Have you encountered these problems when using an oral liquid sealer ?

With the development of industrial technology, industrial automation has become a trend. Nowadays, enterprises are beginning to use automated packaging machinery. Machinery is more efficient than manual, but it is inevitable that there will be problems in the process of mechanical operation. You can already summarize the common problems and daily maintenance of many packaging machines. Everyone summed up the common problems of oral liquid sealing machine and the basic solutions, I hope to help.

The first problem is the simpler problem. When the oral liquid sealing machine is running, the speed is inconsistent. When walking and stopping, the back panel of the oral liquid sealing machine can be disassembled. If the motor gearbox is connected with the shaft, There is slack or shedding at the place, and the screws are fixed again so that they can match. If the problem cannot be solved, it may be because the main motor is operated by the carbon brush contact. Therefore, if the wear is particularly serious, if it is not completely in contact with the slip ring or the friction is not good, the oral liquid sealing machine will not work continuously. Only need to replace the same type of carbon brush to solve the problem.

In addition, irregular lines or bubbles appear in the product seal, which are also common faults. Although it will not leak the inner packaging, it will affect the quality of the product. This kind of failure occurs in the oral liquid sealing machine. It may be because the equipment is used for a long time. When it is hot, it will stick to plastic debris or dust, which will cause high temperature. The belt is uneven, not smooth, etc., so that the sealing portion is not heated uniformly, and bubbles appear after pressing by the cold pressing wheel. At this time, if you replace the high temperature belt or clean it, you can eliminate the fault. Sometimes the irregular bump marks on the cold pressure rubber wheel will be reflected on the packaged items. At this time, there will be many obvious marks on the seal. Make sure the package is beautiful and you need to replace the device.

When the sealing temperature can not be adjusted according to actual needs, the temperature of the equipment can not be well controlled. The fault is mainly caused by the failure of the thermometer, the sealing is easy to burn or the sealing is not strong, the sealing is easy to deform, and the effect is very ugly. The reason for this is that the thermometer is damaged, it needs to be repaired, or the thermocouple is damaged. The temperature cannot be sensed and then transmitted to the thermometer. The thermocouple needs to be replaced. If these can't solve the problem, then it is possible that the quality of the composite itself is not good enough, and the temperature of the heat seal coefficient is different.